Currently, the maximum supported line speed is 300 m/min. The actual maximum speed depends on the system configuration.

The minimum detectable surface defect size varies with lens magnification, while the minimum detectable lump/neckdown height depends on the sampling rate.

Typical values are:

• Surface defects: at 1× magnification, the minimum detectable defect size is approximately 0.05 × 0.05 mm.
• Lump/neckdown defects: at a sampling rate of 80 kHz, the minimum detectable height is approximately 0.01 mm.

For specific applications, please refer to the product selection guide and the Surface Defect Inspection System Brochure, or contact our sales/technical support team for configuration recommendations.

Surface defects are detected using AI models and computer vision technology, while diameter and lump/neckdown detection use telecentric optical technology.

Yes. DALA systems are already used in a variety of fixed-length cutting applications and support output signals such as pulse and digital outputs to work with cutting machines.

The final configuration should be confirmed based on line speed, accuracy requirements, cutting method, and on-site conditions.

The system has minimum size requirements for the measured product. Currently, the smallest verified cable diameter is 0.2 mm.